P2 led soft screen is the most widely used LED soft screen at present, mainly used to make indoor cylindrical screen, curved screen and wave screen. The P2.5 led soft screen has a point density of 160,000 points/㎡, and is made of SMD 2121 copper wire lamp beads, flexible PCB boards and flexible bottom shells, and the screen body flexibility can reach 120 degrees.
The main technical parameters of P2 led soft module are introduced:
- Model : P2
- Dot spacing: 2mm
- Pixel density 250000
- Module resolution 12864
- Module size 256mm128mm
- Pixel composition 1R1G1B
- led lamp beads SMD 1515
- Viewing distance ≥2M
- Viewing angle horizontal 160, vertical 120
- Peak power 1100W/㎡
- Average power 330W/㎡
- Control method Synchronous control
- Drive mode 1/32
- sweepRefresh rate ≥3840HZ
- White balance brightness ≥1000CD
- Brightness adjustment level 0-255
- Computer operating system winXP or aboveVideo signal RF, S-Video, RGB, RGBHV, YUV, YC, etc.Mean time between failures ≥1000 hoursLife ≥100000 hoursOut of control rate ≤0.002
At present, the main models of led soft screen are: p1.875, p2, p2.5, p3, p4 and other products, P2.5 led soft module is a product with high density in led soft screen, high refresh rate: using high Brush IC design to ensure high refresh rate of the product. Long lifespan: LED lifespan is more than 100,000 hours (ten years), and viewing angle is large: the indoor viewing angle can be greater than 160 degrees, and the outdoor viewing angle can be greater than 120 degrees. If you want to know more about LED soft screen prices and solutions, please feel free to contact us.Main features of P2 led soft screen1. The installation of flexible LED display can be any curved surface, which is suitable for artistic modeling;2. It is suitable for curved display such as stage background, exhibition hall, indoor conference room, etc.;3. The installation of the flexible LED display screen has a good on-site installation structure. It adopts strong magnet adsorption type installation and direct adsorption, which is convenient for installation and maintenance. And the security and stability are high.4. The PCB adopts flexible soft board, and the mask and bottom shell are made of rubber;5. The connection between modules adopts high-end connector – HDMI connector;6. Using distributed scanning and modular design technology, higher reliability and stability;7. High grayscale and high refresh rate design: the grayscale level can be 10-16bit, and the refresh rate can be 400-1500Hz, so that the LED display can present images without delay and smear.